Elbow Grease. With the pose I was planning I found it difficult if not impossible to position the arms in a sweeping motion because of how the saber stock was placed on the forearms. Much like some of the mods I've done for the Chimera, I was trying to avoid this modification as much as possible (since joints are trickier to modify owing to the fact that they are high stress points, and a poorly done modification can cause more problems than it solves). The OCness won in the end, and I proceeded in hacking lower elbow joint in two to turn the forearm 90 degrees so that the saber stock is behind the arm.
Much like the Knee modification, this one required a little bit of foresight to determine the maximum area I needed to cut to maintain the joint's overall integrity. I sawed the joint portion down 1mm below the base using the slide lock of the ABS frame as a depth guide.
The resulting parts are rebuilt over one another through a series of overlapping pieces of cut plaplates shaped to fit the resulting crevices. The plaplates provided enough hold area, fitting snugly within the modified part that it holds even without cementing the parts together yet.
Test fit (after only 5 hours of curing).
I've also thickened the collar further with additional shaped plaplates to compliment the layered armor look as well as enhance the overall balance of the shoulders.
1 comment:
Incredible forearm mod. The sabre mounts look great there. The collar thickening has improved the proportion of the head in relation to the V fin as well.
Post a Comment