Wednesday, February 23, 2011
The X Walker Part VII
Another quick update:
High Impact Plastic Sheets (HIPS) as they are called, are also polystyrene sheets similar if not the same as branded plaplates like Tamiya, but are a bit softer and actually easier to shape and work with. Tamiya plaplates although sturdy and stiff, actually breaks easier when bent along the grain, whereas HIPS of the same thickness can bend farther without breaking even when bent along the grain. It also has less tensile strength or spring and is less likely to counter its bent shape, hence easier to form as a curved surface.
Since I'm still avoiding putty at this point, I had to bend the slab two ways; perpendicularly at first, then at an angle corresponding to the curve of the section I'm building to.
This particular section covers the side that encases the vulcan gun.
Up next, the weapons. Will finish this within the week, and hopefully paint it on the weekend.
Subscribe to:
Post Comments (Atom)
The Newbie Stash
Source This is a collection of specific guides for reference in Gunpla Building and Modeling in General. • Gunpla™ and Modeling Terminolog...
-
Gunpla “grades" are scale and complexity indicators. You should be able to start building any grade without difficulty, as long as you ...
-
We've known for quite some time now that if one needs a reference to a certain Gundam kit manual, one only needs to go to either Dalong ...
-
With the intent of going full AB, dropping if not minimizing my use of Bosny spray cans, I got an Airbrush + compressor set from a friend ...
2 comments:
hi where'd you get this HIPS? can it be found here in the Philippines?
Jolis at España near UST.
Post a Comment